The Daily Register - Harrisburg, IL
  • How to Avoid Losing Screws

  • Sliding stock supports keep pieces in your workspace
    • email print
  • To prevent short workpieces from falling through the jaws of his Workmate, Club member Don Ayers, of Houston, Texas, installed 2x 6-in. stock supports on the bottom of one of the jaws. The supports have slotted screw holes so they can be retracted behind the jaw faces when not needed. Fender washers between the screw and supports allow you to tighten the screws so the supports are snug but can still slide.
    Brought to you by: <a href="http://americanprofile.com">American Profile</a>

    Comments are currently unavailable on this article

      Events Calendar